Rotalink SP3616 Gearbox & Motor 6 -26VDC 2000:1 Gear ratio.

Rotalink SP3616 Gearbox  & Motor 6 -26VDC 2000:1 Gear ratio

Model #: SP3616 9-26VDC

Gearbox and Motor

Voltage: 6-26VDC

2000:1 Ratio

Demension:

Height: 62.9mm

W: 47.65mm

General Specification

motor:  D3218-11650CS (Short shaft)

The 225 gearbox is at a ratio of 20000:1

The adaptor between the motor and gearbox is 1.8mm in thickness

The loom (wires) are UL1061 24AWG, 96mm +- 5mm in length, and stripped and tinned 6mm +-1mm

The connector parameters are as follows:

Zinc plated pressed steel gearbox case and front cover. Acetal spur gears running on fixed steel spindles.

Stainless steel shaft, sintered bronze front and nylon back bearing.

Maximum temperature 80ºC at the gearcase

A new and unique approach to motion control You will find here a new and unique approach to motion control. The design philosophy has been to innovate, keeping a keen eye upon the application of well understood technology. The resulting product is user-friendly and lowers the cost barrier by a mile, making serious motion management systems available to all.

The flexibility Access the vast range of standard brushed or brushless dc motors. Interface with gearboxes which are designed to meet the exacting standards of the twenty first century. Use encoders which allow the use of standard components. The result, a unique servo built to meet your specification.

Magnetic Specification Supply Voltage 5Vdc Output Differential SSI or 5V Analogue Max. Rev. Count 1rev. single-turn 32000rev. multi-turn Position retention no limit single-turn up to 100 hours multi-turn Angle Resolution 0.35º (10 bit) Accuracy ±1.5º Maximum SSI frequency 1Mhz Connector 10 way molex

Rotalink’s magnetic absolute encoder uses hall effect based electronics to produce the same analogue output from a smaller package. It also gives the option to report position via SSI (synchronous serial interface), which is immune to the noise that can disrupt an analogue output.

Mechanical Specification Supply Voltage 5-30Vdc Output 5-30V Analogue Max. Rev. Count 1rev. single-turn 10rev. multi-turn Position retention no limit single-turn no limit multi-turn Angle Resolution only limited by EMI Accuracy ±1.5º Connector Soldered leads

A mechanical absolute encoder – commonly known as a potentiometer – is the simplest way track shaft movement over one or ten turns. Its resistance rises as the gearbox turns, providing an analogue signal. The single-turn version drops back to its minimum resistance (~30Ω) when a full rotation in completed. The multi-turn version increases to maximum resistance over 10 turns, then hits an end stop